Description

PSX Penetrating X-treme Premium Seal™ is an invisible/natural-look penetrating sealer. It is used to protect and seal any commercial or high-traffic area and can be applied in both vertical or horizontal applications. It protects surfaces against damaging effects of water intrusion, acid rain, deicing chemicals, freeze/thaw exposure, airborne dirt and smog. It is easy to apply and retains the original appearance of the surface.

Applications

• Concrete Pavers
• Permeable Pavers
• Clay/Brick Pavers
• Wetcast
• Retaining Walls

Instructions

CLEAN

• Wait 28 days after installing polymeric sand before sealing.
• Thoroughly sweep surface of joint sand or loose material.
• Spot clean if needed with one of the SRW Specialty Clean™ products. Then, prepare the surface with an SRW Products General Purpose Cleaner.

CLIMATE

• After cleaning, wait at least 24 hours before sealing. Surface and joints must be completely dry.
• Recommended application temperatures are 50°F - 80°F (10°C - 27°C) from installation through the cure process.
• Do not apply if inclement weather is forecasted within 24 hours.

APPLY

• STIR THOROUGHLY
• Apply with an SRW Products approved Slit Foam Roller and sprayer.
• For best results, spray then back roll. This prevents an uneven finish. A 2-person application is recommended.
• Start at the highest project elevation. Do not allow sealer to pool on surface or in joints.

CURE

• Allow sealed area to dry and cure 24 hours.
• Protect area from water and rain until dry.
• Dry-tack free: 25 minutes
• Foot traffic: 24 hours
• Vehicle traffic: 72 hours

Note all calculations based on 68°F-77°F (20°C-25°C)